Of all the steps in a nanopore run, loading the Flow Cell is the one that makes people hold their breath. You have spent hours on extraction, library prep and cleanup, and now everything depends on a few drops of liquid going through one small port. So how do you do it without introducing bubbles, wasting library, or damaging the pores?
The good news is that the whole procedure comes down to three steps. Once you understand why each one exists, it stops feeling like a high-wire act and starts feeling routine.
Step 1: Check for a small bubble under the cover
Before anything touches the Flow Cell, look closely at the area under the cover. Sometimes a small bubble hides there, and you want it gone before any liquid goes in. If you see one, set your pipette and gently draw back a small volume of about a few µl through the priming port. The bubble moves with the liquid and leaves the Flow Cell, so your priming mix has a clean path ahead of it.
Step 2: Prime the Flow Cell
Priming prepares the Flow Cell to receive your library, and it happens in three small movements.
- First load. Load 800 µl of the priming mix into the Flow Cell through the priming port, taking care not to introduce air bubbles. Then wait five minutes.
- Open the sample port. Gently lift the SpotON sample port cover to allow free flow of liquid for the next step.
- Second load. Load 200 µl of the priming mix through the priming port, and not through the SpotON sample port. Again, avoid air bubbles by leaving a small volume of liquid in the pipette tip.
A tip from Oxford Nanopore: for best results, perform the 200 µl flush immediately before loading the library into the Flow Cell. Timing it this way keeps the Flow Cell wet and ready, so there is no long gap between priming and loading.
Step 3: Load the library dropwise
Just before loading, mix your library gently by pipetting up and down. Then add 75 µl of sample to the Flow Cell through the SpotON sample port, one drop at a time. Make sure each drop flows into the port before you add the next. It is slow, and it can feel tedious, but patience here is what protects your run from bubbles.
Quick summary
| Step | What you load | Where | Volume |
|---|---|---|---|
| 1. Remove bubble | Draw back liquid | Priming port | A few µl |
| 2a. First prime | Priming mix | Priming port | 800 µl |
| 2c. Second prime | Priming mix | Priming port | 200 µl |
| 3. Load library | Library | SpotON sample port, dropwise | 75 µl |
Watch the video
Video loading on the Adwoa Biotech Channel
Related Content
- Oxford Nanopore sequencing: how it works
- PacBio vs Nanopore: comparing long-read platforms
- The sequencing platform series
Reference
Oxford Nanopore Technologies. (n.d.). Flow Cell loading instructions. https://nanoporetech.com
Subscribe by Email
Follow Updates Articles from This Blog via Email


No Comments